Zortrax M200 printer Forum Index

Zortrax M200 printer
Here is the forum to exchange, share feedbacks, and tips for our great Zortrax products.

 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

Extruder Gear Won't Turn

 
Post new topic   Reply to topic    Zortrax M200 printer Forum Index -> HARDWARE { M200 } -> TROUBLESHOOTING
Previous topic :: Next topic  
Author Message
BackstreetZAFU


Offline

Joined: 16 Jan 2016
Posts: 1

PostPosted: Sat 16 Jan - 03:16 (2016)    Post subject: Extruder Gear Won't Turn Reply with quote

PublicitéSupprimer les publicités ?
Hi Everyone,

I'm a new Zortrax user. I've done about three prints so far. Last night, I set a project up to print and came back in the morning to find it had only printed halfway. I started again to find that the reason it had cut off is because the extruder gear became "locked" and wouldn't rotate to push the filament through. I disassembled the housing to check for debris - I found a little bit, but nothing too substantial. I reassembled everything, but the problem persisted. I've attached a video for reference. Can anyone tell me what's going on, or how to fix this? It's frustrating, especially on a newer machine.

http://www.sendspace.com/file/u6ljqu

Thank you!

matt


Back to top
kodzak


Offline

Joined: 11 Apr 2016
Posts: 1
Localisation: Poland

PostPosted: Mon 11 Apr - 23:03 (2016)    Post subject: Extruder Gear Won't Turn Reply with quote

Hi

I have similar problem, but usually it have clicling sound on start.




How do you handled the problem?


Back to top
alinasiri


Offline

Joined: 10 Jan 2017
Posts: 1

PostPosted: Tue 10 Jan - 22:58 (2017)    Post subject: Extruder Gear Won't Turn Reply with quote

kodzak wrote:
Hi there I am Having the same problem I was wondering if you guys found a way to fix it


Thanks,
Ali







Back to top
Contenu Sponsorisé






PostPosted: Today at 06:09 (2017)    Post subject: Extruder Gear Won't Turn

Back to top
Display posts from previous:   
Post new topic   Reply to topic    Zortrax M200 printer Forum Index -> HARDWARE { M200 } -> TROUBLESHOOTING All times are GMT + 2 Hours
Page 1 of 1

 
Jump to:  

Portal | Index | Create own nforum | Free support forum | Free forums directory | Report a violation | Conditions générales d'utilisation
Powered by phpBB © 2001, 2005 phpBB Group